Search results

Update: I decided to reinstall Windows 11 and to my surprise the problem went away. Right now I can reboot Windows with no problem but I haven't installed any drivers. Before reinstallation the pc had only drivers and armory crate and L-connect so one of this was causing problem.

At I told you in the update. It is very unstable at first I thought memory@6000 is the culprit but after a few start and restart later sometimes even @4800 it also caused the problem. Anyway, I still think the memory is the problem somehow HWinfo causes some conflicts with memory and restart...

I tried to disable either Drive Scan and SMbut one at a time and if I enabled either one of them it caused the problem. That's why I came back to look at the memory speed. I don't AI suite only Armory Crate.

update : Even at 4800 sometimes it is not working.

Ok I ran extensive tests and here is the conclusion. 1. If I enabled EXPO @ 6000 enabled Drive scan and SMBus caused the problem. 2. If I disabled EXPO and run memory at 4800 no problem at all. 3 At both 6000 and 4800 I cannot enable EC support as I caused the problem.

Good News!! I disabled both drive scan and SMBus and the problem goes away. I can now restart the PC. What do you think could be the problem? Is my motherboard defective?

I will try. But to provide you with more information, if I power down and power up the system there is no problem so the problem is limited to restart only.

Tried disable EC support still the same problem. Here is the debug file. Just open HWinfo without opening any sensor reading can cause the problem. Please help me.

I left for work already, will report back tomorrow.

How? I think I did not enable it.

The screenshots above happened right after I launched HWInfo to collect debug and report file and restart the system. The screen went blank first so I have to hard reset that's why it says POST attempt failing then the second screen appear after I pressed F1 to enter bios screen and exit to boot...

Just run for 1 - 2 minutes can cause the problem. Asus EC sensor is already disabled.

I run HWinfo on Asus X670e + 7800X3d + PNY4090. Everything works flawlessly however if I attempt to restart the PC it either go to black screen or can enter BIOS config screen and all text turn from English to French one by one line or instant BSOD with different error such as can't load xxx.sys...